Nogueira EXPRESS-5040, Instruction Manual

Page: 31 / 176

Instructions Manual
31
PLACING THE CORDS
Disconnect the power socket and the tractor engine.
See that the needles are lowered. If required, manually turn the hand wheel, in
the direction of the arrow on it, until the needles are totally lowered.
Lock the knotmaker.
Take the end of the cord, from inside roll A, and put it on the points 1, 2, 3, 4,
5, 6, 7, 8 (tip of the needle) and tie it to the needle support 9.
Take the end of the cord, from inside roll C, and put it on the points 10, 12, 13,
14, 15, 6, 7, 16, 17 (tip of the needle) and tie it to the needle support 18, as
shown in the figures below.
Note:
The correct pressure of the springs D is indicated in this manual.
When the machine is activated, the needles will take the cords inside
the knotmakers and automatically fasten them.
6
7
8
9
4
5
6
C
1
A
ATTENTION!
Carefully note the sequence and the points where the
cords must go. A correctly placed cord must not be
loose or run freely.
fig. 41
fig. 43
fig. 44
10
11
2
12
14
15
16
17
18
fig. 42
3
13
D
D