Nlynx MinIT6000, User Manual

Page: 15 / 96

Setup Wizard
About
The Setup Wizard is used for the terminal's initial setup but will also run after resetting the unit back to it’s
factory defaults. To reset the unit back to its defaults, refer to the System section under
Configure
Terminal Properties .
You can use the Setup Wizard to set the basic terminal network configuration and display parameters
however; any of these parameters can be changed later by entering the “Control Panel” and selecting the
appropriate icon.
There are several dialog and configuration boxes, as shown below, that you must navigate through to
complete the Setup Wizard process.
To display the next dialog box in the sequence:
•
Click the Next or Accept buttons
To return to the previous dialog box:
•
Click the Back button
To quit and go directly to the Desktop:
•
Click the Cancel button
Welcome Window
This dialog box shows product information.