Nilfisk-Advance Advance Retriever 2060, Service Manual

Page: 83 / 165

4/99 Form No. 56040694 © 1999 Nilfisk-Advance, Inc. Printed in USA
56418834 SHAKER TIMER KIT
For Advance 2060 / Nilfisk SR 1800
CONTENTS OF KIT
ITEM PART NO. QTY DESCRIPTION
56040694 1 Instruction Sheet
A 56491870 1 Time Delay
B 56002824 1 Scr, Pan Phil 10-24 x 1.25
C 56002768 1 Nut, Hex Nyl Loc 10-24
INSTALLATION INSTRUCTIONS
WARNING!
DISCONNECT BATTERY BEFORE SERVICING.
1 Turn the key switch OFF and disconnect the battery.
2 Open the Side Access Door to access the Circuit Breaker Panel Assembly.
3 Mount the Time Delay (A) as shown with the (B) Screw and (C) Nut from the kit.
4 Directly above this location, hanging from the wiring harness are the wires needed to connect the Time Delay (A) .
5 There is a tab connector with two Black wires connected to it and another with two Orange wires. A third with a Red/Blk wire and a fourth with a
Red/Brn wire. These last two will have a jumper wire between them, remove and discard this jumper wire.
FRONT
A
B
C
1 2 3
6 5 4
TOP
RED/BRN BLK ORN
RED/BLK
6 Connect these wires to the Time Delay according to Figure 2.
7 Close Access Door and re-connect the battery.
8 Test the Time Delay for proper operation, the Shaker should remain
ON for 15 seconds after releasing the Shaker Switch.
FIGURE 1
FIGURE 2