Nilfisk-Advance Advance Retriever 2060, Service Manual

Page: 123 / 165

6/01 Form No. 56040752 © 2001 Printed in USA, Nilfisk-Advance, Inc. (page 1 of 4)
56419405 HEATER KIT
For Retriever™ 2060 / SR 1800
CONTENTS OF KIT
ITEM PART NO. QTY DESCRIPTION
56040752 1 Instruction Sheet
1 56419250 1 Heater Assembly
2 56419364 1 Bracket, Heater
3 56001856 2 Scr, Hex Hd 1/4-20 x 2.25
4 56009012 2 Scr, Hex Thd Form 10-24 x .38
5 56002701 3 Nut, Hex Nyl Loc 5/16-18
6 56001939 3 Wsh, Flt SAE 5/16
7 56419366 1 Conduit (8ft / 2.43 m)
8 56477613 8 Tie, Cable
9 56172230 1 Term. .25 Ins. Tab
INSTALLATION INSTRUCTIONS
WARNING!
DISCONNECT THE BATTERY BEFORE SERVICING.
1 Drain the cooling system.
Gasoline Engine Instructions:
2
See Figure 1. Remove Heater Hose (A) from the engine.
3 Using the heater hose from the kit, cut 2 pieces from it. One approximately 5 feet (152 cm) long and the other approximately 4 feet (122 cm) long.
NOTE: These lengths are approximate and may need to be adjusted.
4 Connect the 5’ (152 cm) hose to port (B) and the 4’ (122 cm) hose to port (C).
5 Cut the Conduit (7) into two appropriate lengths to cover the two heater hoses and slip over each hose.
FIGURE 1
A
A
Side View Rear View
B
C
B
C
Heater