FORM NO. 56043097 / Adgressor
™
/ BR 850S, 850CS, 950S, 950CS, 1050S, 1050CS - 69
ELECTRICAL SYSTEM
Turning the High Speed Scrub Option On or Off:
FACTORY DEFAULT: ON
The control system on the Adgressor/BR 850S and 850CS are programmed to limit the maximum speed while scrubbing to a value less than that
allowed for driving when not scrubbing. The speed select switch on the control panel will override this speed limit feature and allow scrubbing at
maximum speed. If it is desired to prevent scrubbing at this faster speed the speed select feature can be turned off. To turn this feature on or off
perform the following steps:
1 Turn the main power key switch to the off position.
2 Press and hold the speed select switch.
3 While holding the speed select switch turn the main power key switch to the on position.
4 Continue to hold the speed select switch until the speed select indicator is green.
5 Release the speed select switch. The status display will now indicate “E” or “d”.
6 Pressing and releasing the speed select switch will now select between “E” for enabled or “d” for disabled. Enabled means that the high speed
scrub feature is turned on, disabled means that the high speed scrub feature is turned off.
7 To save the new setting turn the main power key switch to the off position.
8 The new setting will be saved and will remain in effect until it is changed again.
Scrub Deck Motor Type Selection:
FACTORY DEFAULT: MODE = S (SCRUBBER), SIZE: 8 IF 28” OR 32” DISC OR ANY CYLINDRICAL DECK, “L” IF 35” OR 38” DECK.
The Adgressor/BR 850S and 850CS can be equipped with numerous scrub deck options. This function confi gures the control unit current settings
for each of the scrub deck types. Improper setting of the motor type may result in motor damage due to overloading. To select the proper scrub
deck motor type:
1 Turn
the
main power key switch to the off position.
2 Press and hold the scrub system off and scrub pressure increase switches.
3 While holding both switches turn the main power key switch to the on position.
4 Continue to hold both switches until the scrub pressure increase indicator is yellow.
5 Release both switches. The status display will now indicate “S” or “E”.
6 Pressing and releasing the scrub pressure increase switch will now select between “S” for scrubber and “E” for extractor. Make sure that
“S” is displayed.
7 Press
the
scrub system off switch to save this setting.
8 The status display will now display “4”, “6”, “8” or “L”. Pressing the scrub pressure increase switch will now select between the four settings.
Select “8” if the machine is equipped with a 28” or 32” disc-type scrub deck or any size cylindrical scrub deck. Select “L” if the deck is equipped
with a 35” or 38” disc-type scrub deck.
CAUTION!
Improperly setting this parameter can result in serious damage to the machine. If this is set for motors not installed on the machine, the
motors may be overloaded which can cause overheating and permanent damage to the motors. It could also create a fi re hazard.
SPECIAL PROGRAM OPTIONS (CONTINUED)
Summary of Contents for Adgressor BR 1050CS
Page 81: ......
Page 82: ...www nilfisk advance com 2006 ...