Nikon NPL-632, Instruction Manual

Page: 54 / 206

3 Getting Started
40 Field Station NPL-632 Instruction Manual
Selecting the target set
A target set specifies settings for the target type, the
prism constant, and height of target. When you change
the selected target set, all three settings are changed.
You can use this function to quickly switch between
two types of target. You can prepare up to five target
sets.
Press
[HOT]
to display the HOT menu. Then either press
[3]
, or select
Target
and press
[ENT]
. A list of the five target sets appears. To select a target set, either press the
corresponding numeric key (
[1]
through
[5]
), or use
[^]
or
[v]
to highlight the target set in
the list and press
[ENT]
.
To change the settings defined in a target set, highlight the target set in the list. Then
press the
Edit
softkey.
Entering a field note
To enter a field note, press
[HOT]
to display the HOT
menu. Then either press
[4]
, or select
Note
and press
[ENT]
.
This function can be used at any time on any
observation screen.
Each note can be up to 50 characters.
The note is stored as a CO record in the raw data.
To display a list of previously used notes, press the
Stack
softkey. The stack stores the last 20 notes.
Use
[^]
or
[v]
to highlight a note in the list. Then press
[ENT]
to select the note.
Type Prism / N-Prism
Const
-999 to 999 mm
HT -9.9900 to 99.9900 m
HT can be left blank in the target set. If you leave it blank, the current HT value is always applied to the
measurement.
When a target set is selected, the Type and Const values are copied to both
[MSR1]
and
[MSR2]
settings, and to
the measurements in Qcode. If you have specified a value for HT, this value is also copied to the current HT.