TITAN 912L Actuator
INSTALLATION REFERENCE MANUAL
8
|
www.hysecurity.com Nice/HySecurity, 6705 S 209th St, Ste 101, Kent, WA 98032 - TF: 800-321-9947 MX4685 Rev. A ©2019
AFFIX GATE BRACKET TO ACTUATOR ARM
3
1/2”x 2” BOLT
BLACK GATE
BRACKET
ACTUATOR
ARM
1/2” WASHER, ZINC
(GALVANIZED
BRACKET ONLY)
1/2” LOCK
NUT
IMAGE 3-1:
GATE BRACKET TO ACTUATOR USING BOLT, WASHERS, & NUT
WASHER (STAINLESS
STEEL)
WASHER (ZINC)
IMAGE 3-2:
GATE BRACKET TO ACTUATOR USING HITCH PIN AND R-CLIP
HITCH PIN
R-CLIP (INSERT INTO HITCH
PIN HOLE)
HOLE FOR R-CLIP
The bracket may be connected to the actuator arm using the 1/2” x 3” bolt, washer, and lock nut (IMAGE
3-1).
A hitch pin and R-clip are included in case fast decoupling of the actuator from gate is required. Note that
the mechanical release on the actuator motor may be opened to allow manual operation of the gate in
the event of a power failure without need for decoupling from the gate.
NOTE:
There are two styles of bracket, black or silver (galvanized) and either one may be included in
the actuator kit. Both brackets are installed the same, except for different washer count. See next page
for images of both brackets after installation to the actuator arm using bolt, washers, and nut, as well as
hitch pin and R-clip.