5.
Right-click the cRIO-905
x
in the project and select
Deploy All
to deploy the module in
the Real-Time (NI-DAQmx) programming mode.
Your module is now in Real-Time (NI-DAQmx) mode.
Programming Examples
For information on getting started with DAQmx programming mode examples in
LabVIEW, go to
and enter the Info Code
criodaqmx
. You can also access
example projects in LabVIEW by selecting
Help»Find Examples
, and navigating to
Hardware Input and Output»CompactRIO
.
Adding the cRIO-905x to a LabVIEW FPGA Project
Complete the following steps to create a new LabVIEW FPGA project configured with the
cRIO-905
x
controller.
LabVIEW FPGA Module is required to program the user-accessible FPGA on the cRIO-905
x
or deploy C Series modules in the LabVIEW FPGA program mode. To program in Real-Time
(NI-DAQmx) or Real-Time Scan (IO Variables) modes, the LabVIEW FPGA module is not
required. Refer to
Adding the cRIO-905x to a LabVIEW Project
Refer to "Choosing Your Programming Mode" in the
cRIO-905x User Manual
to determine
which programming modes are right for your application.
1.
To create a new LabVIEW project, launch LabVIEW and click
Create Project
.
2.
Select
Templates»LabVIEW FPGA Project
.
3.
Select the
CompactRIO Embedded System
project type and click
Next
.
The
System Setup
window opens, which will allow you to add your system to the
project.
4.
Under
Discover existing system
, check the box next to
Device is connected to a remote
subnet IP address
.
cRIO-905x Getting Started Guide
|
© National Instruments
|
23
