STEP 1
Make a long press of button 3.
The led change color cyclically red and green.
Release the button corresponding to the sensor you want to set
LED colour
Output paired with TX
red
Wind sensor
green
Rain sensor
blu
Sun sensor
STEP 2
Make a short press of hidden button.
The led start Flashing.
5.
3 CONFIGURATION OF THE FUNCTIONALITIES OF THE SENSORS
With this procedure the sensors are tested.
ATTENTION: to carry out the test the sensor must be active, see paragraph 5.2
ACTION:
long presso button 3
LED:
changes color cyclically
ACTION:
short press hidden button
LED:
led start Flashing
WIND
SENSOR
RAIN
SENSOR
SUN
SENSOR
STEP 3A
To carry out the test turn the wind
sensor (wind gauge) blades by
hand: the control unit will make a
brief opening movement followed
by a brief closing movement. When
the test is completed the control
unit turn off the led and will beep 4
times.
In any case, the control unit exits
the procedure after 60 seconds or
when a key is pressed.
STEP 3B
To carry out the test wet the
sensitive part of the rain sensor:
the control unit will make a brief
opening movement followed by
a brief closing movement. When
the test is completed the control
unit turn off the led and will beep 4
times.
In any case, the control unit exits
the procedure after 60 seconds or
when a key is pressed.
STEP 3C
To carry out the test illuminate
the sensitive part of the sensor or
expose it to the sun: the control
unit will make a brief opening
movement followed by a brief
closing movement. When the test
is completed the control unit turn
off the led and will beep 4 times.
In any case, the control unit exits
the procedure after 60 seconds or
when a key is pressed.
ATTENTION
After entering the test, this mode is exited:
- if the corresponding sensor does not intervene within 60 seconds (to exit immediately press a button)
- if the corresponding sensor activates, to exit the test the alarm must be deactivated (wind = vanes stopped, rain =
sensor dry, sun = sensor in the shade)
10
