ems100
Product Manual, Issue 4
www.nexo.com
Page 35
3.11
Viewing statistics
Depending on the model, the controllers start gathering a variety of statistics when first powered up.
Statistics provide information on the following, dependent on firmware:
`
Activity: Number of motion counts and door openings.
`
Compressor: Number of compressor cycles and total compressor runtime.
`
Operation: Settings of the activity frequency (AF) parameter and the saving temperature
disable (PEr) parameter.
`
Temperature: Lowest and highest temperature measured on the appliance sensor in the past
24 hours.
Note
A full reset clears all the gathered statistics.
Please see the following list which describes the statics available to view on your
controller model.
To view the statistics, press the Up and Down buttons simultaneously. Statistics include door opening,
compressor cycles and activity counts.
The controller then scrolls through the statistics pausing for 20 seconds at each statistic before returning to
normal operation. The 3-digit display can show values from ‘0’ to ‘999.’
For values of 1000 and above, the display shows the value as a rounded decimal number. For example, 1.1
represents 1100, 1.2 represents 1200, and so on.
Display
Statistic
Description
Activity frequency
Value of the activity frequency AF parameter. Possible values
are: 0, 1, 2 or 3.
(0 = low, 2= high and 3 = automatic)
Compressor cycles
Total number of compressor cycles since first powered up or
last full reset
Compressor
runtime
Total number of hours that the compressor has run since the
controller was first powered up or since the last full reset.
Door openings
Total number of door openings since first powered up or last
full reset
Highest
temperature
Highest temperature measured by the appliance sensor during
the past 24 hours.
Lowest temperature
Lowest temperature measured by the appliance sensor during
the last 24 hours.
All manuals and user guides at all-guides.com
