42
If it is necessary to clean the glass more thoroughly, we recommend using an approved stove
glass cleaner, generally available from your stove retailer. (Follow the glass cleaner
manufacturer’s instructions).
3.3.5 Cleaning and checks inside the firebox
.
Cleaning and maintenance only to be carried out when the stove is not in use and cold.
Inner firebox:
Brush the inside of the firebox clean from time to time to check the integrity of the
plates and liners etc. See section 2.2.2 for details of removeable parts of the stove. It is not
normally necessary to paint inside the firebox due to the high temperatures that mean that the paint
does not have much effect before being burnt off. The side and bottom bricks firebox linings may
require replacement occasionally depending upon fuels and the type of usage experienced. If the
firebox side or bottom brick linings are damaged or worn replace with manufacturers
recommended parts, it is essential that the steel behind any bricks is not exposed to the fire.
Firebox side and bottom brick linings are not covered by warranty, as they are a wearing
consumable part. Visually check the rear brick and all other parts, if damaged or worn consult an
approved and competent stove installer such as Hetas registered (England & Wales), or equivalent
for other nations.
Baffles:
It is essential to check the top of the baffles for build up of soot and ash regularly weather
the stove has been used or not used. From time to time remove the baffles if necessary, to ensure
that the flue way entrance is completely clear. Baffle plates will require replacement from time to
time and are a wearing consumable part.
Visual checks
: Make visual checks to the inside and outside of the stove if any other items are
found to be worn damaged or cracked consult a suitably approved stove installer and do not use
the stove until any fault is rectified.
Stove controls
: Check the stove controls for full and free movement if any ash or debris is
restricting the use of the controls, clean, as necessary.
Air Supply:
It is essential to check any air supply ventilator in the property is fully clear and open
if installed.
Clearances:
Check that any combustible materials are a safe distance from the stove.
3.3.6 External surface cleaning
Cleaning and maintenance only to be carried out when the stove is not in use and cold.
The steel surface of the Easedale 5 SE stove is painted with black heat-resistant paint. It is best
maintained by simply vacuuming it with a soft brush attachment or wiping it down with a dry,
dust-free cloth, but only when the stove is not in use & fully cold.
If the stove is used too vigorously, the painted surface may assume a grey tinge over time, but the
stove can easily be freshened up with an approved heat resistant spray paint which is generally
available from your local stove retailer.
Summary of Contents for Easedale 5 SE
