![Newman Easedale 5 SE Installation & User'S Instructions Download Page 29](http://html1.mh-extra.com/html/newman/easedale-5-se/easedale-5-se_installation-and-users-instructions_1679779029.webp)
29
3.1 Maximum fuel loads and choice of fuel.
Maximum fuel load
Stove model
Wood
Smokeless fuel
Easedale 5 SE
2 x Small to meduim sized logs maximum total
weight 1.2kg
Total weight
0.75kg
Important note:
The Easedale 5 SE stove is only to be used with either wood or approved
smokeless fuels as listed, it is not to be used with a combination of wood and approved smokeless
fuels.
Recommended fuel: Seasoned hardwood
Use Seasoned hardwood logs with a moisture content of 16% plus or minus 4 %
Never use wet wood or unseasoned wood.
Suitable hardwood is available commercially and normally sold in bags, ensure if your fuel is
sourced this way that it meets the criteria above. It is recommended that your fuel supplier uses a
managed and renewable source.
Pieces of wood with a diameter greater than 7cm should always be chopped. The pieces of wood
should be short enough to be able to lie flat over the layer of embers, with air at both ends. The
maximum length of wood to be no more than
25cm.
Maximum fuel load wood
.
The maximum fuel load to be one or two small to medium sized logs (total weight 1.2kg) this
should burn for about an 0.83hour before needing to refuel, then the appliance is operating at its
nominal heat output of approximately 5.0Kw.
Ensure the wood fuel does not obstruct the tertiary air inlet holes to the rear of inside of stove. The
wood fuel to be placed below all tertiary air inlet holes.
Ensure that all wood is placed so as not to touch and obstruct the glass and door when closed, all
fuel to be loaded behind the banking bar, ensuring that all fuel does not project passed the banking
bar.
Recommended fuel:
Approved smokeless fuels, the Easedale 5 SE was tested using Maxibrite.
Maximum fuel load approved smokeless fuel
The maximum fuel load for approved smokeless fuels to be a total weight of 0.75kg. This should
burn for about an hour before needing to refuel, then the appliance is burning at its nominal heat
output of approximately 5.0kw.
Summary of Contents for Easedale 5 SE
