Newman Easedale 5 SE, Installation & User'S Instructions

Page: 39 / 53

39
3.3.1 Glass panel fixings & fibre rope seal to rear off stove door
Replacing glass panel to stove door. See figure 6
In the unfortunate event the glass panel to main door gets damaged the glass panel must be
replaced with an approved stove glass panel, by an approved and competent stove installer such as
Hetas registered (England & Wales) or equivalent for other nations.
To change the glass panel, but only when the stove is not in use and completely cold remove the 4
screws and fixing clips to the rear of door. Wear protective gloves and goggles during this process.
When fitting the new glass panel locate the glass so it is central to the stove glass seal and located
onto seal to all glass edges. Replace the 4 screws and fixing clips and secure the glass panel to
door.
DO NOT over tighten the screws as this can damage the glass.
Replacing the glass rope seal

Remove the stove door by removing the 4 screws retaining the hinges to the door and place
face down onto a soft sound surface so as not to damage the door or glass. To replace the glass
panel to door seal. Remove the glass panel. Remove the old rope seal and scrape old glue from
the door locating groove.

Clean the locating groove with a clean, dry cloth to remove all old dust and debris. Use
suitable stove rope glue into the rope locating groove and press the new rope into the locating
groove, noting the joint positions. Replace the glass panel. Refer to the stove rope glue
manufacturer’s instructions for drying times and when the stove can be used after the stove
rope glue has been used.

Using the appliance with a damaged glass seal or damaged glass can cause dangerous fumes to
enter the room, or the appliance to over fire resulting in damage.