14
Distances between stove and a conventional brick Class 1 Chimney.
See: Figure 2A
Refer to current National laws, Building Regulations, & any Rules in Force, including BS
8303 and BS EN 15287-1. Also refer to Approved Document J (England & Wales)
When installing this stove into a conventional class 1
non-
combustible brick chimney built to
current National laws, Building Regulations and any Rules in Force including BS 8303 and BS EN
15287-1 the clearances between the stove and a
non
-combustible brick chimney must comply with
current National laws, Building Regulations & any Rules in Force, however providing all
surrounding non combustible brick walls have a minimum thickness of 200mm the clearance
between the rear & sides of stove can be reduced to 50mm, refer to current National laws,
Building Regulations, & any other Rules in Force. However, it is recommended that the
measurement between the sides & rear of stove to be as large as possible above this dimension, as
the efficiency of this stove is dependent on the clearances as shown in figure 2A.
For all other clearances to a
non-
combustible brick wall and chimney refer to current National
laws, Building Regulations & any Rules in Force, including BS 8303 and BS EN 15287-1:2007.
Contact your local building authority regarding restrictions and installation requirements.
It is recommended that if a
non
-combustible fireplace manufactured from natural stone/marble
Summary of Contents for Easedale 5 SE
