Newland NLS-HR15XX-30, User Manual

Page: 84 / 104

【
Start Setup
】
74 【
Exit Setup
】
Do not Send the Check Digit
Send the Check Digit
Note: by setting “do not send the check digit”, if the data length except for the 1 character check digit is less than the
minimum barcode reading limit, the barcode reading will be failed. (For example: the scanner set the the minimum barcode
reading length of Code 11 to 4 characters and “do not send check digit”, in such circumstances,the scanner is not able to
read the Code 11 with 4 characters. )
Set the Barcode Reading Length
The scanner is only able to read the Code 11 with tramsmission content length falls in the limited range, the range is
consisted of the maximum value and minimum value in units of character (the maximum value and minimum value also
included), the Code 11 exceeds the range can not be read or transmitted.
 Read the barcode of “Set the Minimum Length Limit” to adjust the minimum length limit.
 Read the barcode of “Set the Maximum Length Limit” to adjust the maximum length limit.
Set the Minimum Length Limit
Set the Minimum Length Limit
Note
：
the maximum length limit of any 1D barcode must not exceed 255, if the maximum length is shorter than the
minimum length, then the scanner is only able to read the barcodes with the minimum length and the the maximum length;
if the maximum length equals to the minimum length, then the scanner is only able to read the barcode with such length.
Example: The steps of set the scanner read the Code 11 with barcode length between 8 to 12 characters.
1. Read the
“Start Setup” barcode.
2.
Read the barcode of “Set the Minimum Length Limit”.
3.
Read the numeric barcode “8”, (see the appendix—numeric barcode)
4. Read
the “Save” barcode.(see the appendix—numeric barcode)
5.
Read the barcode of “Set the Maximum Length Limit”.
6.
Read the numeric barcode “1”.
7.
Read the numeric barcode “2”.
8. Read
the “Save” barcode.(see the appendix—numeric barcode)
9. Read the
“Exit Setup” barcode.