Newland NLS-HR15XX-30, User Manual

Page: 77 / 104

【
Start Setup
】
【
Exit Setup
】 67
Turn off the Function of Reading Full ASCII
Turn on the Function of Reading Full ASCII
Set the Barcode Reading Length
The scanner is only able to read the Code 39 with tramsmission content length falls in the limited range, the range is
consisted of the maximum value and minimum value in units of character, the Code 39 exceeds the range can not be read
or transmitted.
 Read the barcode of “Set the Minimum Length Limit” to adjust the minimum length limit.
 Read the barcode of “Set the Maximum Length Limit” to adjust the maximum length limit.
Set the Minimum Length Limit
【
Code
：
99912412
】
Set the Maximum Length Limit
【
Code
：
99912413
】
Note
：
the maximum length limit of any 1D barcode must not exceed 255, if the maximum length is shorter than the
minimum length, then the scanner is only able to read the barcodes with the minimum length and the the
maximum length; if the maximum length equals to the minimum length, then the scanner is only able to read the
barcode with such length.
Example: The steps of set the scanner read the Code 39 with barcode length between 8 to 12 characters.
1. Read the
“Start Setup” barcode.
2.
Read the barcode of “Set the Minimum Length Limit”.
3.
Read the numeric barcode “8”, (see the appendix—numeric barcode)
4. Read
the “Save” barcode.(see the appendix—numeric barcode)
5.
Read the barcode of “Set the Maximum Length Limit”.
6.
Read the numeric barcode “1”.
7.
Read the numeric barcode “2”.
8. Read
the “Save” barcode.(see the appendix—numeric barcode)
9. Read the
“Exit Setup” barcode.
Codabar
Restore the Default Value
By reading the barcode, the parameter setup of Codabar will be restored to the factory default state.