Preparing the Product for Use
19
Check the components of the digital system and make sure that there is no external
damage.
2.5. Assembly and Connection to Computer
If you buy the digital system with the computer, the equipment is delivered with
installed and configured software. If you buy the digital system separately, please,
install the software from the flash drive included in the delivery set.
The software must be installed before the first connection of the digital
system to PC. Read the corresponding section of the user manual before
starting to work.
If the electronic media with the software is not available, please contact
your local dealer. The list of authorized Neurosoft dealers can be found
here:
https://neurosoft.com/en/pages/dealers
.
The digital system consists of the electronic unit and can be supplied with the patient
button depending on the delivery set variant (Fig. 10). The electronic unit and patient
button can be connected to PC either directly or using USB hub (not shown
in Fig. 10). Remember, that the USB connector of the electronic unit (with a blue
mark) and the patient button must be attached to the same USB controller of your PC.
It can be done, if:
·
the devices are attached to one and the same USB hub;
·
the devices are attached to the alongside USB connectors (typically, the connectors
of one controller are located nearby);
·
the devices are attached to different USB hubs but connected to one and the same
USB controller.
Do not use the system with the USB hubs not connected to the mains.
The connection to USB connectors on the monitor or keyboard does not
ensure the correct device operation.