NTI Secure Remote Power Reboot Switch
14
OPERATION VIA WEB INTERFACE
A user may monitor and configure the settings of the IPDU-Sx, the outlets, and any sensor connected to it using the Web Interface
via any web browser (see page 2 for supported web browsers). To access the Web Interface, connect the IPDU-S2 to the
Ethernet (page 5). Use the Device Discovery Tool (page 13) to setup the network settings. Then, to access the web interface
controls, the user must log in.
By default, the IPDU-Sx is configured to dynamically assign network settings received from a DHCP server on the network it is
connected to. (This can be changed to a static IP address to manually enter these settings in the Network Settings on page 33.)
The IPDU-Sx will search for a DHCP server to automatically assign its IP address each time the unit is powered up. If the
IPDU-Sx does not find a DHCP server, the address entered into the static IP address field (page 33 -default address shown
below) will be used. If a DHCP server on the network has assigned the IP address, use the Device Discovery Tool to identify the
IP address to enter when logging in to the IPDU-Sx .
Note: The computer using the Device Discovery Tool and the NTI Device must be connected to the same subnet in order
for the Device Discovery Tool to work. If no devices are found, the message “No Devices Found” will be displayed.
Log In and Enter Password
To access the web interface, type the current IP address into the address bar of the web browser. (The default IP address is
shown below):
Note: If “Allow HTTP Access” (page 33) is not checked to be enabled (disabled by default) , only an SSL-encrypted
connection will be possible. The software will automatically redirect to an HTTPS (secure) connection. The user will
likely see a warning about the SSL certificate and a prompt to accept the certificate. The IPDU-Sx uses a self-signed
NTI certificate. Accept the NTI certificate.
A log in prompt requiring a username and password will appear:
Figure 12- Login prompt to access web interface
Username = root
Password = nti
(lower case letters only)
Note: usernames and passwords are case sensitive
http://192.168.1.22
