Network Electronics SDI-IP-GTW, User Manual

Page: 42 / 82

SDI-IP-GTW User Manual
42
Figure 20. IP TX page
The left part of screen shows a three containing all the SDI input ports.
Select a port by pressing the port name. The information to the right of
the page is related to the selected stream.
3.6.1 Main
The IP TX main sub-page is where you configure most of the
parameters related to a stream to transmit over the IP network
.
3.6.1.1 Input Configuration
Enable input: Tick this box to enable an input. If this is not ticked, you
will not receive any SDI stream in this input. The input port will be grey
in the status view (See Section 3.4.)
Input name: Enter a name reference to an SDI input stream.
3.6.1.2 Input Status
SDI sync detected: Yes if the unit is receiving a valid stream on the SDI
input interface.
SDI format:
Shows the format of the SDI signal received. May be either
625 or 525 lines.
3.6.1.3 IP TX Parameters
Enable IP transmission:
Select the checkbox to enable the SDI input to
be sent on the IP network.