Network Electronics SDI-IP-GTW, User Manual

Page: 12 / 82

SDI-IP-GTW User Manual
12
o
WEB/XML based remote control
o
Easy access to unit from any WEB browser
o
Easy integration to Network Management System (NMS) with
SNMP Trap support
1.5 Guided Tour
1.5.1 The User Interface
All connectors are provided at the rear panel. Configuration and
monitoring of the unit is performed via a FLASH-based WEB interface
using a standard WEB browser such as Internet Explorer. The unit also
supports configuration via upload of XML configuration files. Once
configured, the unit runs without the need for further intervention
unless system configuration requirement change.
1.5.2 Front Panel Description
The front panel provides four LEDs per SDI-IP-GTW. Table 1 describes
the meaning of the different LED indicators.
Table 1. Front panel LEDs
Indicator Colour Description
Power Green This LED is lit when power is being received by the
unit.
Alarm Red This LED is lit when a failure is detected by the unit.
I.e. at least one alarm with severity level "Critical" is
present.
IP TX Blue This LED is lit when the unit is configured to transmit
data to the IP Network.
IP RX Yellow This LED is lit when the unit is configured to receive
data from the IP Network
1.5.3 Rear Panel Description
All connectors to the SDI-IP-GTW are provided at the rear panel. Figure
3 shows the rear panel of a SDI-IP-GTW equipped.
1. SDI in . In IP Tx mode, the connector provide a SDI input. In IP Rx
mode, the connector provides an SDI input for digital Genlock input.
2. SDI output . In IP Rx mode, the connectors provide an SDI output.
When no data is received on the IP data port a black picture is
transmitted.
3. SDI test . In IP Tx mode, the connector provide a loop-through SDI
output. In IP Rx mode, the connector provides an SDI output.
4. Management port . The SDI-IP-GTW provides one Ethernet port for
control and management of the unit.