Network Electronics SDI-IP-GTW, User Manual

Page: 17 / 82

SDI-IP-GTW User Manual
17
The SDI-IP-GTW should be installed to allow adequate flow of free-air.
Ensure that the ventilation holes on each side of the SDI-IP-GTW are
not blocked and allow at least 50 mm free air-space at each side of the
unit. The SDI-IP-GTW is designed to be stacked in 19"racks without
ventilation panels between. In systems with stacked units, it may be
required to use forced-air cooling to reduce the operating ambient
temperature.
Figure 4 shows the air path through the unit.
Figure 4. Air Path though the unit
2.2.6 To connect the equipment
Once the SDI-IP-GTW is installed in its intended operating position, it
is ready to be connected to the rest of the system provided that this is
already in place. The following figure shows the different equipment
connections.
Figure 5. Signal connections
Remove mains supply previous to move or install the equipment.
Ensure ESD precautions are observed whilst interconnecting
equipment.
2.2.6.1 SDI port
The SDI-IP-GTW can be operated in two modes: IP Transmit and IP
Receive mode.