15
4. 5
LED and button functions
Button functions
Controlling
the output
Press 3x
within 1 to 5 seconds to switch the output.
AP mode
activation
Press and hold for 10 seconds
in the standard operating mode.
Hold until the yellow LED (1) starts flashing rapidly.
The AP mode is activated, making it possible to connect to the device and change the
WiFi network to which it should connect.
Restoring
factory
defaults
Turn the device off,
press and hold the button and turn the device on
. Hold the button
pressed
for at least 10 seconds
. The device is reset to factory defaults and the AP mode
is activated (green LED flashes rapidly for 1 second, then yellow LED starts flashing
rapidly).
LED indicators
Status
LED (1)
Yellow
Off
No WiFi connection
On
WiFi connected
Rapidly flashing
& red is off
AP mode
Slowly flashing
& red is off
Restoring WiFi connection/
Waiting for DHCP
3 fast flashes every second
& red is off
Locate function – for one minute after enabling in
the web administration
Red
Flash
Activity (command received over M2M)
Output
LED (2)
Green
Off
Output relay open
On
Output relay closed
Quick flashing for 1sec
“Load to defaults & AP mode” activated
All
LEDs
Yellow,
red, green
Shortly on
During system boot (e.g. after powering up or
rebooting the device)
4. 6
Minimum system requirements (for configuration)
A device with an Internet browser (Firefox, Chrome, Safari, Microsoft Internet Explorer, Opera, Mozilla
etc.) that has JavaScript and cookies enabled.
Summary of Contents for PowerCable Modbus 101 Series
