Netio PowerCable Modbus 101 Series, Manual

Page: 65 / 79

65
Telnet connection to a PowerCable device IP address and its Telnet port
When t he connect ion is est ablished, t he PowerCable device ret urns t he f ollowing response and is
ready t o receive commands.
Telnet welcome message
100 HELLO B166A626 - KSHELL V2.0
Not e: The Telnet connect ion is aut omat ically t erminat ed af t er 60 seconds of inact ivit y. It is possible
t o use t he
noop
command t o keep t he connect ion alive f or t he next 60 seconds.
Command set
Command Description
login <username>
<password>
Log in a user.
Replace <username> and <password> by t he
equvalent at t ribut es def ined in t he Telnet
prot ocol conf igurat ion (Figure 42)
<password>
Example
– log in
with
username
net i o
and
password
passwd
:
login netio passwd
quit Log out and t erminat e Telnet connect ion.
noop Keep t he Telnet connect ion alive f or t he next
60 seconds.
No-operat ion
port list Ret urns st at e of out put .
port list
250 1
(out put is ON)
port <out put > <act ion> Cont rol t he out put .
<out put > is replaced by t he out put number (1)
<act ion> is replaced by a paramet er described
below
If no <action> is provided, the state of the
output is returned.
Each command must be f ollowed by CR and LF charact ers (hexadecimal 0D and 0A). Typically, you
can use Ent er in t he t erminal.