UM-00006 v1.1
www.netcommwireless.com
NTC-8000 – M2M Multi-Port Network Gateway
45
3.
Enable the DHCP Server on Access Point 1:
Figure 42 - WDS - Access Point 1 DHCP Server Settings
4.
Click Wireless Settings and then Basic. Enter the required details as listed in the table below:
Figure 43 – WDS - Access Point 1 Repeater Mode Setup
OPTION
DEFINITION
Radio On/Off
The Wireless Radio must be turned on in order to use WDS. Set this to ON.
Country
Select the country where the gateway is operating.
Network Mode
Depending on the capability of your wireless device’s wireless network card select the network mode
to use. There are 5 available options. They are:
11 b/g mixed mode
11b only
11g only
11n only
11 b/g/n mixed mode
If you are not sure which protocol to use set this option to 11 b/g/n mixed mode.
Frequency (Channel)
The frequency or wireless channel that the gateway is broadcasting with. Recommended channels are
1, 6 or 11.
Frequency (Channel)
The frequency or wireless channel that the gateway is broadcasting with. Recommended channels are
1, 6 or 11. You may use any channel except AUTO in order to use WDS.
SSID
The SSID (Service Set Identifier) or network name in use for the wireless network.
