Reinstall Fibre Channel HBA
The replacement Fibre Channel HBA is installed into the same location as the one that
was removed.
What you’ll need
• You have the correct replacement Fibre Channel HBA.
• You have removed the existing Fibre Channel HBA.
Steps
1. Wrap the strap end of the ESD wristband around your wrist, and secure the clip end to a metal ground to
prevent static discharge.
2. Remove the replacement Fibre Channel HBA from its packaging.
3. With the blue adapter latch in the open position, align the Fibre Channel HBA with its connector on the riser
assembly; then, carefully press the adapter into the connector until it is fully seated.
There are two adapters in the riser assembly: a Fibre Channel HBA and an Ethernet network adapter. The
Fibre Channel HBA is indicated in the illustration.
4. Locate the alignment hole on the riser assembly (circled) that aligns with a guide pin on the system board
to ensure correct riser assembly positioning.
156
