6
Step 3.
Stand the upper stand assembly on the floor with the slotted bars facing upward as shown below. Then position
one of the stand legs on the
outside
of one of the slotted bars with the bolts extending through the slot as shown.
The short end of the base bar should be on the same side as the cross bar (shown below)
Step 4.
Raise the leg all the way until the top bolt is at the highest point in the slot. Place a washer on the exposed bolt
ends and then thread the locking levers onto the bolts.
Tighten the locking levers to hold leg in this position.
Step 5.
Repeat this procedure for the other leg.
Be sure to set both legs at the same height and then lock the levers
securely.
Place leg on
outside
of
slotted bar with bolts
extending through slot
Put flat washer on bolt threads first
before locking levers.
Note: The shorter end of the base
bars (with locking casters) should be
on the same side as the stand cross
bar.
Cross Bar
