25
Testing the feeder
Step 1.
Turn the speed control knob up a little bit and then press the JOG/RESET button to start the motor at slow speed.
Watch the first envelope advance from the feed area towards the delivery table.
Step 2.
While holding the RESET/JOG button, watch the first envelope advance into the delivery table. The envelope
should enter the delivery table between the paper guides. Continue to hold the button to advance the
envelope(s) down the delivery table.
If your envelopes appear to advance down the delivery table unrestricted, you can release the RESET/JOG
button to stop the motor. (Note: The motor will continue to run until the 4 second timer elapses, OR the
envelope reaches the stop sensor at the end of the delivery table)
Step 3.
With a small stack of envelopes in the hopper, turn the speed control knob up to approximately 50% of maximum
speed (12:00 position on dial indicator), then press the RESET/JOG button to start the motor. (do not hold)
Turn speed control up a little
and then press and hold the
RESET/JOG button to start
advancing an envelope
Envelope should advance
into the delivery table
paper guides without
catching or dragging.
With the speed set on 50%
press the RESET button
