Nederman FlexPAK 800, Setting Manual, Page: 20 / 44

FlexPAK 800/1000 EN
20
4 PLC settings
The following PLC displays show the different settings that can be configured for the unit.
4.1 Find a parameter and set its value
ESC OK
Thu 10:45
2018-02-01
ESC OK
Stop >
Program >
Setup >
Network >
Diagnos ti cs >
ESC OK
Set Parameter
Program Name
ESC OK
FlexPak
Hi Vacuum Unit
OFF
Time To Service
2000 hours
ESC OK
H-Meter 1/1
MI =2000h:0m
OT =0h:15m
MN =1999h:45
MN Ext =2000
ESC OK
H-Meter >
SSR_Time >
Cool_Tmr >
ClenCyl >
FItClean >
DIRTime Z
Do the following to find a parameter and set its value:
1. From the PLC status screen, press the down arrow to go to the date and time
screen.
2. Press ‘Escape’
ESC
to go to the main menu.
3. Press the down arrow to go to ‘Program’. Press ‘OK’
OK
to confirm.
4. Select ‘Set Parameter’. Press ‘OK’
OK
to confirm.
5. Use the up or down arrows to find the parameter. Press ‘OK’
OK
to confirm.
6. Use the left and right arrows to select a value.
7. Use the up or down arrows to set the value. Press ‘OK’
OK
to confirm.
8. Press ‘Escape’
ESC
to go to the main menu.
9. Press ‘Escape’
ESC
to go to go to the date and time screen.
10. Press the up arrow to exit.
NOTE!
There are several other input menus on the same level as the date and time screen.
If pressing the down arrow takes the PLC to one of those menus, use the left arrow
to get to the date and time screen.
NOTE! The blinking cursor shows the current value that can be changed.