![background image](http://html1.mh-extra.com/html/nec/powermate-professional-service-05-1997/powermate-professional-service-05-1997_service-manual_4143936205.webp)
CD-ROM Reader Specifications and Jumper Settings
D-2
Table D-1 Specifications for Sixteen-Speed NEC CD-ROM Reader
Feature
Specification
Supported Formats
CD-Audio, CD-ROM (mode 1 and mode 2), CD-ROM
XA (mode 2, form 1 and form 2), Photo CD (single
and multiple sessions), CD+ (Plus); CD-I(FMV), Video
CD, CD Extra
General Specifications
Interface
IDE/ATAPI
Capacity
656 MB, Mode 1
748 MB, Mode 2
Disc
Loading
Motorized Front Loading (power tray with holder)
MTBF (power-on hours)
70, 000 hours (10% duty cycle)
MTTR
30 minutes
Weight
2.27 lb. (1.03. kg)
Relative
Humidity
(operational)
30% to 70% (no condensation)
Operating Temperature
5°C to 45°C
CD-ROM READER CONNECTORS AND JUMPER SETTINGS
The back of the NEC sixteen-speed CD-ROM reader provides the following connectors and
jumpers (see Figure D-1):
Analog audio line output connector — 4-pin male connector that connects the
reader to the system’s sound system via an audio cable.
Digital audio line output connector — 2-pin male connector.
Configuration jumpers — enable or disable the cable select feature, slave device
configuration, or master device configuration. The CD-ROM reader is factory set
as the master device on the secondary PCI/IDE channel.
IDE connector — connects the reader to the secondary PCI/IDE connector on the
system board via an I/O cable (see Appendix A for system board connector
locations).
Power connector — connects the reader to the power supply via a power supply
cable. Pin 1 pr12V, pins 2 and 3 are ground, and pin 4 pr5V.
NOTE:
The front of the CD-ROM drive
contains a headphone output connector (3.5 mm
mini-jack).
Summary of Contents for POWERMATE PROFESSIONAL - SERVICE 05-1997
Page 13: ...xiv Contents...
Page 203: ...C 4 Hard Disk Drive Specifications...