Configuration Procedures
5-9
Updating Network Values
When you submit a command to update a network value, the current value appears on
the EXPRESSSCOPE® Monitor LCD with a blinking cursor under one digit (refer to
Figure 5-3
).
Figure 5-3 Setting IP Address Value
1. Use the left and right navigation arrows to move the cursor to the desired digit.
2. Use the up and down navigation arrows to adjust the value under the cursor, where
the following behavior applies:
y
Roll-up and roll-down actions (that is, increasing or decreasing the values)
have intelligent behavior. For example
-
If the current value is 168 and the cursor is on the rightmost digit (8) when
you press the up arrow, the value 168 rolls up to 169.
-
169 rolls up intelligently to 170, not 160.
-
170 rolls down intelligently to 169, not 179.
y
You can change octet values (group of three digits) easily by moving the cursor
to the desired octet and then rolling the value up or down rather than changing
each digit separately.
y
You cannot enter invalid values.
y
All values are in decimal notation.
3. When the value is set correctly, press
OK
.
The EXPRESSSCOPE® Monitor LCD displays a message to apply or cancel the
changes, as shown in
Figure 5-4
.
Figure 5-4 Applying IP Address Changes
Summary of Contents for NECCare Platinum Express5800/A1160
Page 1: ...EXPRESS5800 A1160 Service Processor Troubleshooting Guide...
Page 10: ......
Page 52: ...456 01807 000...
