NEC NECCare Platinum Express5800/A1160, Troubleshooting Manual, Page: 34 / 52

Configuration Procedures
5-6
See 5.3.1 Configuring Network Settings .
2. Use remote console interface to move the cell that your restored Service Processor
is in back into the partition.
See 5.3.4 Moving Cells to Other Partitions .
3. Use remote console interface for your partition to verify partition settings, including
customer data details for Call Home packets.
See 5.3.5 Specifying Partition Settings .
4. Use remote console interface for your partition to verify user credentials.
See 5.3.6 Adding User Credentials using Remote console interface .
5. Use remote console interface for your partition or cell to load Secure Socket Layer
(SSL) certificates onto your Service Processor so as to eliminate browser startup
warnings.
See 5.3.7 Eliminating Browser Startup Warnings using Remote console interface .
6. Use remote console interface for your partition to verify alert notifications.
See 5.3.8 Configuring Alerts and the SMTP Server using Remote console interface .
5.3. Configuration Procedures
This section provides detailed instructions for the possible configuration procedures you
might want to perform.
5.3.1. Configuring Network Settings
The Service Processor has a separate network connection for each cell and partition in
the system. If you display the network menu from a cell menu, the values pertain to that
cell. If you display the network menu from a partition menu, the values pertain to the
partition to which the cell belongs. All cells in a partition display the same partition values
but unique cell values. You can update partition values from any cell in the partition.
Note: After your Service Processor is restored to default settings, DHCP is not enabled
and static IP addressing is used. To enable DHCP addressing on your partition and cell
1. On the main menu of the EXPRESSSCOPE® Monitor LCD on your cell, use the
navigation buttons to select Partition, and then press OK.
2. On the partition menu, use the navigation buttons to select Network, and then
press OK.
3. On the network settings menu, use the navigation buttons to select Set DHCP and
press OK.
The value changes to On.
Updating Network Settings