NEC NEC Express5800 Series, Online Service Manual

Page: 180 / 198

Emergency Management Port Console C-15
Using the Sensor Type Code Table
Compare the
Sensor Type and Number
message shown in the SEL viewer display (above) to the
Sensor Type/Number in Verbose column in the table below. Using information in the
Sensor
Name
column in the table you can determine the physical component which generated the SEL
message. The
Generator ID
column in the table identifies the microcontroller which reported the
event to the SEL. Detailed information regarding the event is available from the
Event Description
column in the SEL Viewer.
For example, if there is a Fan #10 entry in the
Sensor Type and Number
column of the SEL Viewer,
by looking at the Sensor type Codes table you can determine that the Baseboard Fan 1 caused this
entry. The entry was reported through the Baseboard Management Controller (BMC) on the
system board.
Sensor Type Codes
Sensor Type and Number in Verbose Sensor Name Generator ID
Reserved 00h BMC
Temperature #17 Processor1 Temp BMC
Temperature #18 Processor2 Temp* BMC
Temperature #19 Baseboard Temp1 BMC
Temperature #1A Baseboard Temp2 BMC
Voltage # 01 Baseboard 5V BMC
Voltage # 02 Baseboard 3.3V BMC
Voltage # 03 Primary Processor BMC
Voltage # 04 Secondary Processor* BMC
Voltage # 05 Processor 2.5V BMC
*Not applicable to all servers