NEC N8403-019, (Japanese) User Manual

Page: 107 / 146

87
Chapter 5 Creating Virtual Disk
This section describes the WebBIOS configuration utility.
1. Before Using WebBIOS
Before configuring RAID, the system BIOS of your server system must be set up.
If you have executed [Load Setup Defaults] in BIOS SETUP, you must change the parameters as described
below.
To setup the system BIOS, press F2 when the screen as shown below appears after powering on the server
(while POST is running).
Press<F2> to enter Setup or Press <F12> to network
Press<F2> to enter Setup or Press <F12> to network
 Enable Option ROM Scan
Select [Advanced] [PCI Configuration] [Mezzanine Type 2 Option ROM] and change the
parameter value from [Disabled] to [Enabled].
 Disable the parameters for the onboard SCSI controller.
Select [Advanced] [Embedded SCSI] and change each parameter as follows:
SCSI Controller: [Enabled] [Disabled]
Option ROM Scan: [Enabled] [Disabled]
RAID Enable: [Enabled] [Disabled]