NEC N8100-1644F, User Manual

Page: 512 / 547

Installing Windows Server 2003 G-7
Create from the menu which appears when running NEC Express5800 Server with
NEC EXPRESSBUILDER.
If you have only NEC Express5800 Server to create Windows Server 2003 OEM-Disk for
EXPRESSBUILDER, use this procedure.
If Windows Server 2003 or Windows can be operated on NEC Express5800 Server, you can use the
other procedure described later.
Follow the steps below.
1.
Prepare one Flash FDD, or one USB floppy disk drive and 3.5-inch floppy disk.
2.
Turn on your NEC Express5800 Server.
3.
Insert the NEC EXPRESSBUILDER DVD-ROM into the optical disk drive of the server.
4.
Press the RESET switch or press
Ctrl
,
Alt
and
Delete
to reboot the server. (You may also
turn off and then on again to reboot the server.)
The system will boot from the DVD-ROM and NEC EXPRESSBUILDER starts.
5.
Select [Create the OEM-DISK for Windows] from [Tools Menu] step.
6.
Connect the Flash FDD or the USB floppy disk drive.
(If you use the floppy disk drive, insert a floppy disk into it.)
7.
Select [Create an Windows Server 2003 OEM-Disk for EXPRESSBUILDER] at [Create
OEM-Disk] and click [Perform].
8.
Windows Server 2003 OEM-Disk for EXPRESSBUILDER will be created.
Write-protect and attach a label, then keep it safely.
IMPORTANT:
If you have created "OEM-Disk" in the Flash FDD, disconnect the
Flash FDD after NEC EXPRESSBUILDER had been shut down.
NOTE:
If the following message is displayed, the floppy disk is
write-protected.
Cancel write-protected state.
If you have already cancelled write-protected state, connect the floppy
disk drive again.