NEC MC2200, User Manual

Page: 89 / 142

Upgrading Your System 4-23
„
The SCSI termination resistors must be installed in the last SCSI drive of the daisy
chain cabling. If the SCSI tape drive is your only SCSI device on the SCSI controller
B, termination must be enabled in the tape drive.
Installing a 5.25-Inch Media Device
!
CAUTION
CD-ROM devices contain a laser system and are classified as
CLASS 1 LASER PRODUCTS. To use these devices, thoroughly
read the documentation provided by the CD-ROM manufacturer,
and keep the documentation for future reference. In case of any
trouble with a CD-ROM, please contact your nearest service
representative. To prevent direct exposure to the laser beam, do not
try to open the enclosure. Use of controls or adjustments or
performance of procedures other than those specified in the CD-
ROM manufacturer's documentation may result in hazardous
radiation exposure
1.
Power off the system, unplug the system power cords, and remove the appropriate
side panel depending upon the bay you are installing the media device in. (See page
4-3 for directions.)
2.
Open the front door as shown in Figure 2-4.
!
CAUTION
Observe static precautions. Use an antistatic wrist strap.
3.
Carefully remove the front system bezel by releasing its two plastic snap tabs on the
back of the bezel and pulling it out (see figure below).