NEC MC2200, User Manual

Page: 64 / 142

3-22 Configuring Your System
3.
Insert the BIOS FLASH diskette into Drive A.
4. Enter PHLASH and press ENTER.
5. After the system reboots, load the default values by pressing F2 to enter setup. At
the Exit Menu, select GET DEFAULT VALUES.
6.
Clear the event log by selecting CLEAR EVENT LOG at the Server Menu. Press
space bar to change NO to YES and press ESC. Select SAVE CHANGES & EXIT
and press ENTER to continue. The system will reboot.
If the procedure fails, perform the following steps and then retry the Update BIOS
procedure.
1.
Turn off the system and remove the panels as described in the Upgrades and
Options chapter.
2.
Ensure the FLASH Code jumper J6A is set to pins 1-2 to enable updates to the
BIOS (see Figure 3-1).
3. Replace the panel and power up the system with the BIOS FLASH diskette inserted
in Drive A
Resetting the CMOS NVRAM
To reset the CMOS NVRAM:
1. Power off the system and remove the panels as described in the Upgrades and
Options chapter.
2. Move the CMOS Clear jumper J1B to pins 2-3 (see Figure 3-1).
3.
Turn the system on and wait for the POST to complete. This will automatically
reprogram the CMOS NVRAM to the default settings.
4.
Power off the system.
5.
Move the CMOS Clear jumper to from pins 2-3 to pins 1-2.
6.
Replace the panels and power on the system.
7.
Run the Setup Utility to configure your system.
Clearing and Changing the Password
To clear and change the password:
1.
Power off the system and remove the panels as described in Chapter 4, Upgrading
Your System.
2.
Move the Password Clear jumper J2B to pins 2-3 (see Figure 3-1).
3. Power on the system and wait for POST to complete. This automatically clears the
old password.
4. Power off the system.
5. Move the Password Clear jumper back to pins 1- 2.