3. Duplex LAN Configuration
Express5800/R310e-E4, R320e-E4, R320e-M4, R310f-E4, R320f-E4, R320f-M4 Maintenance Guide (Windows)
156
Chapter 2 Configuring and Upgrading the System
3.2.3
Configuring Duplex LAN
The following explains how to configure duplex/dual LAN.
The screen images used in this section are for Windows Server 2012 R2.
Important ft server is not supporting Windows Server 2012 NIC teaming (LBFO). Please build
duplex LAN configuration in the following procedure.
Note
Because the configuration from the remote site may fail, you need to log on as an
Administrator or a member of Administrators group.
Before replacing the back panel of CPU I/O module, 1000BASE-T 2ch board set
(N8804-012), or 10GBASE-T 1ch board set (N8804-011), be sure to remove duplex
LAN, and create a team after the replacement.
See
Chapter 2 (3.2.4 Removing Duplex LAN)
for how to remove duplex LAN.
See
Chapter 2 (3.2.3 Configuring Duplex LAN)
for how to configure duplex LAN.
The screen images are subject to change because of the network driver version.
Substitute as appropriate when content has been modified.
(1)
Start Device Manager.
Select
Start Screen
-
Administrative Tools
(or
Start
-
Administrative Tools
) -
Computer Management
-
Device Manager
.
Note
If network adapters are duplicated as shown below, remove all network adapters from
Device Manager
, and select
Action
–
Scan for hardware changes
.
Stratus emb-I350 2-Port Gigabit Adapter
Stratus emb-I350 2-Port Gigabit Adapter
Stratus emb-I350 2-Port Gigabit Adapter #2
Stratus emb-I350 2-Port Gigabit Adapter #2
The display will be as follows when the actions are performed properly.
Stratus emb-I350 2-Port Gigabit Adapter
Stratus emb-I350 2-Port Gigabit Adapter #2
Stratus emb-I350 2-Port Gigabit Adapter #3
Stratus emb-I350 2-Port Gigabit Adapter #4
When using 10GBASE-T, the network adapter names are shown in "Stratus X540 1-Port
Copper 10 Gigabit Adapter" and "Stratus emb-X540 2-Port Copper 10 Gigabit Adapter".
Summary of Contents for Express5800/R310e-E4
Page 267: ...MEMO...
