1. Installing Internal Optional Devices
Express5800/R110h-1 User’s Guide
39
Chapter 2 Preparations
1.2
Overview of Installation and Removal
Install/remove components by using the following procedure.
The internal components except for hard disk drives must be installed or removed after dismounting the server
from the rack. See
Chapter 2 (2. Installation and Connection)
for details.
CAUTION
Be sure to observe the following precautions to use the server safely. Failure to
observe the precautions may cause burns, injury, and property damage. For
details, refer to
Safety Precautions and Regulatory Notices.
•
Do not drop the server
•
Do not leave the server pulled out of the rack
•
Replace the cover after installing components
•
Beware of high temperatures
•
Do not get your fingers caught when installing components
If the server is mounted on a rack, use UID Switch to identify the target server.
1.
See
Chapter 2 (1.3 Confirming Servers (UID Switch))
.
Remove the front bezel.
2.
See
Chapter 2 (1.4 Removing the Front Bezel)
.
Turn off the server.
3.
See
Chapter 3 (6. Turning off the Server)
.
Disconnect the power cord from the outlet and the server.
4.
Important After disconnecting the power cord from the server, wait for at least 5
seconds before continuing to work because the components on the
motherboard might still be operating for 3 to 4 seconds even after the power
cord was disconnected.
When installing or removing DIMMs, TPM Kits, PCI cards, redundant fans, optical disk drives,
5.
redundant power supply unit, and Flash Backup Units for RAID Controller, dismount the server from
the rack and place it on a flat and hard desk.
See
Chapter 2
(
2.1.2 Installing the server to the rack or removing it from the rack – (2) Removal
procedure).
If installing only additional hard disk drives, go to step 11.
Important Do not leave the server open on the rack.
Remove the top cover.
6.
See
Chapter 2 (1.5 Removing the Top Cover)
.
