1. Turning on the Server
Express5800/R110h-1 User’s Guide
105
Chapter 3 Setup
4. POST displays the result of memory test, CPU status, and other messages.
Tips
The value of memory capacity shown in the message may be smaller than the
actual physical memory depending on the hardware configuration. This applies to
the information in SETUP and system information of the operating system
5. After a while, the following message is displayed on the screen.
Press <F2> SETUP, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network
Tips
When
Server
→
Power Measurement Policy
is
One time
or
Always
, the power
measurement message appears instead of the above message. Wait until the
measurement is complete.
You can call the functions below upon completion of POST by pressing the function key.
<F2> key: Run BIOS Setup Utility (SETUP). For details, see
Chapter 3 (2. BIOS Setup Utility
(SETUP)
)
.
<F3> key: Run EXPRESSBUILDER from Internal Flash Memory. For details, see
Chapter 3 (4.
EXPRESSBUILDER)
.
Note
Note that the server dose not boot from Internal Flash Memory when a bootable
CD/DVD-ROM is set on the drive.
<F4> key: Run the offline tool. For details, see
Chapter 1 (9. Offline Tools) in "Maintenance Guide
".
<F12> key: Boot from network.
6. When the boot mode is legacy BIOS and a controller which has the dedicated BIOS is installed, a
message that prompts you to start the utility is displayed.
Example: optional RAID controller
Press <Ctrl> <R> to Run MegaRAID Configuration Utility
The utility starts by pressing <Ctrl> + <R> keys.
Example: on-board RAID controller
Press <Ctrl> <M> to Run LSI Software RAID Configuration Utility
The utility starts by pressing <Ctrl> + <M> keys.
For details on the utility, refer to the manual supplied with each optional board.
Depending on the hardware configuration, the message "Press Any Key" might appear to prompt a
key entry. This is a behavior of the BIOS of the optional board. Continue to operate after checking the
manual of the optional board.
7. If you set a password in BIOS Setup Utility, the password entry appears upon successful completion of
POST.
Up to three password entries will be accepted. Three incorrect password entries disable the server to
boot. In such a case, turn off the power and wait about ten seconds before turning on to boot the server.
Important Do not set a password before OS is installed.
