NEC EXPRESS5800/140He, Service Manual

Page: 145 / 184

- 129 -
8.3 POST Error Messages
When the power of the server is turned on, POST (Power On Self-Test) automatically runs to
check the I/O board, memory board, processor, keyboard, and mouse. When POST detects an error,
it displays an error message on the display unit screen. (Some error messages are displayed along
with the action to be taken.)
If the error message listed in the table is displayed on the screen, take a measure according to
"Action" column. When several actions are to be taken, determine the action appropriately.
On-screen message Action
0200 Failure Fixed Disk
•
Replace the hard disk drive.
•
Replace the cable.
•
Replace the HDD cage.
•
Replace the I/O board.
0210 Stuck Key
0211 Keyboard error
•
Connect the keyboard connector again,
and restart the system.
•
Replace the keyboard.
•
Replace the I/O board.
0212 Keyboard Controller Failed
•
Connect the keyboard connector again,
and restart the system.
•
Replace the keyboard.
•
Replace the I/O board.
0213 Keyboard locked – Unlock key switch
•
Check if the key switch has been locked
(being pushed).
•
Replace the keyboard.
•
Replace the I/O board.
0220 Monitor type does not match CMOS –
Run SETUP
•
Start Setup to reconfigure the monitor.
•
Replace the I/O.
0230 System RAM Failed at offset
0231 Shadow Ram Failed at offset
0232 Extended RAM Failed at address line
•
Check if ECC 1-bit/multi-bit error is
recorded in the system event log. If the
error is recorded, replace the relevant
DIMMs in pair.
After replacement, start SETUP and
execute [Clear DIMM Error].
•
Replace the memory board.
•
Replace the I/O board.
0250 System battery is dead – Replace and
run SETUP Replace the lithium battery.
After replacement, start SETUP to set the
current time and date.
0251 System CMOS checksum bad - Default
configuration used This error may occur if the system is
forcedly shutdown during POST.
Start BIOS SETUP to reconfigure the
system.
0252 Password checksum bad - Passwords
cleared Start BIOS SETUP to set the password
again.
0260 System timer error Replace the I/O board.
0270 Real time clock error Replace the I/O board.
0271 Check date and time Settings Start BIOS SETUP to set the date and time
again.
Replace the I/O board.