NEC Express 5800/120Eh N8100 SERIES, User Manual

Page: 72 / 342

4-8 Configuring Your Server
Saving the Configuration Data
IMPORTANT:
If the SATA hard disk drives are used in disk array
configured with the on-board HostRAID, be sure to select [Advanced] -
[Peripheral Configuration] - [SATA Controller Mode Option] -
[Enhanced]. Then, select [Advanced] - [Peripheral Configuration] -
[SATA RAID Enable] - [Enabled]. Leaving this parameter as the
factory-set value (Disabled) may destroy the data in hard disk drive.
To save the current configuration data
Select [Exit] - [Exit Saving Changes] or [Save Changes].
To discard changes to the current configuration data
Select [Exit] - [Exit Discarding Changes] or [Discard Changes].
To load the user-defined default
Select [Exit] - [Load Setup Defaults].
To load the custom defaults
Select [Exit] - [Load Custom Defaults].
To save the custom defaults
Select [Exit] - [Save Custom Defaults].