NDS ExpandOR, Installation Manual

Page: 25 / 52

17
The following sample configuration shows how to transmit from one ExpandOR to another ExpandOR
ExpandOR A transmitting to ExpandOR B:
Click the Transmit tab of the first ExpandOR to set the following configuration:
Configuring ExpandOR to ExpandOR Streaming
IP Address: Enter the transmitter’s IP address in the IP address window under Receive From.
Port : Specify the port to receive the video stream on (e.g. 5004). This must be the same port number
as the transmitting device is sending the video stream .
Press the Save button.
Initiate Transmit/Receive operation using the Web interface or the Front Panel buttons.
IP Address: Enter the receiver's IP address in the IP address window in the Transmit To group box.
Port : Specify the transmit port (e.g. 5004).
ExpandOR B receiving from ExpandOR A:
Click the Receive tab of the second ExpandOR, set the following parameters:
Simultaneous Transmit/Receive Operation:
The procedure described above may be used to configure simultaneous (two way) transmit/receive
operation between two ExpandOR units.
Different port numbers are required for simultaneous (two-way) transmit/receive operation. We recommend
at least a three-digit difference between the port numbers to avoid any conflict.
For example, if ExpandOR A is transmitting on port 5004 and ExpandOR B is receiving on port 5004, then Ex-
pandOR B must transmit on port 5001 or lower, or on port 5007 or greater. ExpandOR A must receive through
the same port as ExpandOR B is transmitting.
Simultaneous Transmit/Receive Operation