NDS ExpandOR, Installation Manual

Page: 15 / 52

7
Power Up Sequence
1. Plug in the ExpandOR’s power supply, but do not turn the unit on.
2. Connect the ExpandOR to the local area network using an RJ-45 cable connection.
3. The
ExpandOR firmware defaults to DHCP mode. Verify that a DHCP server is available in the network prior
to booting up the unit so you can access the ExpandOR and configure it.
4.
Press the power button until its ring illuminates.
Note: If the ExpandOR is being re-installed, or relocated from another network. It is recommended that the
factory defaults are restored before proceeding. See Restore Factory Defaults : Using the Front Panel on page
13 for more information.
5
6. All LEDs are off for about 10 seconds.
7. The
CAPTURE STILL LED illuminates for about 5 seconds, then turns off.
5. The RECEIVE LED illuminates on for about 10 seconds, then turns off.
8. About 30 seconds after the CAPTURE STILL LED turns off, all ExpandOR LEDs will flash for about one
second.
9. When all LEDs turn off, the ExpandOR is ready to be configured.