4-24
BenchMike Pro Instruction Handbook: Setup
This screen allows you to display a +/- sign in front of numerical
values sent through the serial port. If not selected, only negative
numbers will include a sign. Note that the second option is used
to change the format of sent data. When checked, a period will be
used to indicate a decimal point in the data. When not checked, a
comma is used.
NOTE: These settings only affect the format of data sent via the
serial port. Note that the second option is only applicable for non-
English users. While English uses a period to indicate a decimal
place, some other languages use a comma, and those users may wish to alter this setting, based on data acquisi-
tion software requirements.
4.9.7
SQC Batch Setup
Note that the
SQC Batch Setup
page allows you to define the
Batch Count value and decide whether to clear data and/or print
reports at the end of the batch.
4.9.8
Environmental Compensation
Setup
The
Thermal Compensation Setup
tab allows you to define
temperature information so that the BenchMike Pro will automati-
cally compensate for temperature differences. When Thermal
Compensation is active, a thermometer icon will appear over the
part icon in the upper left corner of the screen. All measurements
will then be the theoretical value referenced
to the “Standard
Temperature”.
The
Barometric Compensation Setup
tab shows actual baro-
metric vales. The pressure at the time of calibration is shown as a
comparison to the actual pressure at the time of measurement.
The barometric calibration compensation values are entered at
the time the unit is calibrated by qualified service personnel.
