NCR S46, Manual

Page: 13 / 90

Completing a Factory Installation
NCR S46 Server MP-RAS Support Guide 1-3
Completing a Factory Installation
If your system was pre-loaded at the factory with NCR UNIX SVR4 MP-
RAS, you need to complete the factory installation of the server by
configuring the network.
If you ordered NFS OE (Operating Environment) or C/S OE, STREAMware
TCP for MP-RAS is automatically installed on your server.
Procedure
To complete the software installation, follow these steps:
1. Boot the server. When the UNIX MP-RAS 3.01.01 operating environment
displays, you are asked to configure the network.
2. Answer no to the configuration questions if you do not have the required
information, or type D to exit the configuration screens.
3. Decide if the default pre-installed OE meets your needs. You may need to
re-install the OE if you want to change the file system type for the root file
system or change the system disk layout.
If you want to re-install for these or other reasons refer to the Installing
NCR UNIX SVR4 MP-RAS guide.
If the pre-installed OE is suitable, get the necessary STREAMware
information (contained in the documents listed below), then continue with
Step 4.
–
STREAMware TCP for MP-RAS Transition Guide (D1-4790-C)
–
STREAMware TCP for MP-RAS Administrator Guide (D1-4788-C)
–
STREAMware for MP-RAS TCP User Guide (D1-4787-B)
4. Bring the system to run level 2 (if NFS is running) by typing the
following:
# init 2
5. Configure the network by running the following script:
# /etc/inet/script/tcpconfig.b