National Instruments NI DIDS-2103, User Manual

Page: 107 / 223

NI DIDS-2100 Series User Manual | © National Instruments | 107
SkipFire_PFI_ChnX
Tip Strip: Enables Skip Fire on selected DI channel when EPT Mode is selected.
Detail: Enables the skip fire sequence defined by PFI1_SkipFire_Cycles and PFI1_SkipFire_OnCycle for its
assigned PFI channel.
PFI1_SkipFire_Cycles
Tip Strip: Specifies the period length, in number of cycles, for the skip fire sequence in EPT Mode (Min = 1).
Detail: Specifies the number of cycles included in a skip fire sequence when the PFI injector is operated in
EPT mode. For example, if the number 7 is entered, the PFI injector will continuously repeat a seven cycle
sequence as long as SkipFire_PFI_ChnX is enabled for the desired channel.
PFI1_SkipFire_OnCycle
Tip Strip: Specifies the number of active cycles during skip fire sequence in EPT Mode (Min = 1).
Detail: Specifies the number of active cycles included in a skip fire sequence when the PFI injector is
operated in EPT mode. The length of the sequence is determined by PFI1_SkipFire_Cycles , and the
sequence is enabled by SkipFire_PFI_ChnX for the desired channel. The value is programmatically limited to
values between and including 1 and PFI1_SkipFire_Cycles .
TMP Pulse Enable
Tip Strip: Enables injection pulse
Detail: When ON , the TMP Mode command to the PFI Driver module will be active for the specified duration.
When
OFF
, the command will be inactive, but the specified timing and duration will still be implemented.
Therefore, the timing of the adjacent pulses will remain the same whether the pulse is ON or OFF
Delay Ch1
Tip Strip: Time until beginning of this injection pulse
Units: msec
Detail: Specifies the delay of the start of injection from the trigger event.