National Instruments Direct Injector Driver System Manual
© 2013 National Instruments. All rights reserved.
3.2.2.2 Changing The Network
Settings Of The DI Driver System
This section assumes that a connection with the DI Driver System user interface is already established, and it is
desired to change the IP address. If a connection has never been established, please refer to
established, please refer to
Setting the Controller Network Interface To DHCP
1. After starting the system main user interface, double-click on the
2.) After the
Execution Information
window opens, select the
Network
tab to make changes to the controller
network settings. The settings shown on this tab are similar to the
Windows PC LAN TCP/IPv4 Properties
dialog.
The image below shows an example of changing the controller IP address to 192.168.2.34.
The Default Gateway and DNS Server IP addresses may be important if the system is connected to a network
router. A network administrator should be contacted for this information. If a direct, "point-to-point" network
connection is made between the Windows PC and the system controller, both Default Gateway and DNS Server
addresses may be set to 0.0.0.0.
The Windows PC used to interface with the system must have a similar IP address and Subnet mask as the system
controller, but the IP address must be different in the last address number.