NARDA NBM-550, Operating Manual

Page: 60 / 156

5 Measuring with the NBM-550 and HF probes
50
NBM-550 Narda
Measuring discrete values
✓
You selected
Discrete
as the
Spatial AVG Mode
.
1. Press the
Spatial Average
key.
 Spatial
measurement mode is displayed
The result counter top left shows #0, indicating that
no values have been measured yet.
2. Press the
Measure
key.

The measured value is stored,
#1 indicates that one result has been stored,
Pos. 1 shows the measured value.
3. Press the
Measure
key again to make another
measurement.

The measured values are stored,
#... indicates the number of measurements.
The average of all the measurements is shown after
Pos. 1.
4. When you have recorded all the measured values,
– you can either add positions so you can record more
results (e.g. at different locations) or
– you can store the entire measurement.
Adding a position
1. Press the
Add Position
key.
 Pos. 2
is displayed,
The result counter shows
#0.
2. Record new measured values as described above.
3. You can add more positions and record more results if
necessary.
 Avg Pos
shows the average value for all the positions
measured, along with the positions used to form the
average (e.g. 1-4 for positions 1 through 4).
You can store the measurement results when you have
recorded all the measured values.
Storing the results

Press the
Store
key.

The average of all positions and the averages for
each separate position are stored.