NARDA IDA, Operating Manual, Page: 83 / 292

5.2 Displaying and editing system settings
Narda IDA - 3106
75
Resetting all device settings
You can reset the system settings (except those mentioned under
Resetting
the system settings
) and the measurement settings with this function. This
function is available in all menus.
To reset all device settings:

Any menu is open.
1.
Press and hold down the
ESC
key for 3 seconds.
2.
Press the
OK
key.
– or –

The
Main Menu • Settings • Service Menu
is open.
1.
Press the
Factory Settings
softkey.
2.
Press the
OK
key.
5.2.7 Performing device diagnosis
Main Menu • Settings • Service Menu
This menu allows you to test the function of the LCD monitor, display certain
instrument data and reset the instrument to the factory settings.

Press the
Service Menu
softkey.

The Service Menu is displayed.
To check the display:

Press the
Display Test
softkey.

The basic colors red, blue and green are displayed in turn.
The test stops after three cycles.
 Press the
ESC
key to end the test immediately.
To display the device diagnostics:
 Press the
Device Diag
softkey.

A list of some basic data is displayed.
NOTE:
The displayed data is intended primarily for servicing purposes.
Table 15: Description of Device Diagnostics list
Information Description
Mainboard Temperature Temperature of main circuit board
RF-Board Temperature Temperature of RF circuit board
RF-Board Hardware Version RF board hardware version