Nakayama MB6000, Manual

Page: 11 / 83

EN
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect the performance and safety of the products.
The parts described / illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer's product line with similar features and may not be included in the product
you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and special adjustments, must only be carried out by technicians
of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the product with non-provided equipment may cause malfunctions or even serious injury or death. The manufacturer and the importer shall not
be liable for injuries and damages resulting from the use of non-conforming equipment.
TRANSPORT ΑΤΙΟΝ / STORAGE
Warning: When transporting the tiller, turn the fuel valve OFF and keep the tiller level to prevent fuel spillage. Fuel vapour or spilled fuel may be ignited.
Before storing the unit for an extended period:
• Ensure that the storage area is free of excessive humidity and dust.
•
Drain the fuel.
- With the fuel valve turned to the OFF position, remove and empty the fuel strainer cup.
- Turn the fuel valve to the ON position and drain the gasoline in the fuel tank into a suitable container.
- Replace the fuel strainer cup and tighten securely.
- Drain the carburetor by loosening the drain knob. Drain the gasoline into a suitable container.
• Pull the starter grip until resistance is felt. Continue pulling until the notch on the starter pulley aligns
with the hole on the recoil starter. (Fig. 34)
• Change engine oil.
• Cover the tiller with plastic sheet.
• Ensure that the handlebars are not touching the ground.
Fig. 33 (1) O-ring
(2) Fuel strainer cup
(3) Drain knob
Fig. 34
TROUBLESHOOTING
The engine will not start (Fig. 35)
• Is there enough fuel?
• Is the fuel valve on?
• Is the engine switch ON?
• Is gasoline reaching the carburetor?
• To check, loosen the drain knob with the fuel valve ON. Fuel should flow out freely.
• Retighten the drain knob.
Fig. 35
Problem with the spark plug
• Remove the spark plug cap. Clean any dirt from around the spark plug base, then remove the spark plug.
• Reinstall the spark plug in the plug cap.
• Turn the engine switch on.
• Grounding the side electrode to any engine ground, pull the recoil starter to see if sparks jump across the gap.
• If there is no spark, replace the plug.
• If the spark plug works normally, try to start the engine according to the instructions.
• If the engine still does not start, send the tiller to your supplier for repairs.
11
WWW.NIKOLAOUTOOLS.GR